斗式提升机的用途: the application of bucket elevator.
本厂生产的D、TD、HL、TH系列斗式提升机,深受拥护欢迎。其中TD系列、TH系列提升机具有规格多、输送量大、提升高度高、运行平稳、寿命长等优点。其主要性能及参数符合J8/T3926—99《垂直斗式提升机》(该标准等效参照了国际标准和国外先进标准),㈠L、TH系列的牵引圆坏链符合MT36—80《矿用高强度圆环链》。
本提升机适用输送粉状、粒状、小块状的无(或小)磨琢性的散状物料,如:砂、水泥、煤、焦末、碎石、粘土、矿石等,D、TD系列被输送物料的温度不超过60C,如果采用耐热
式胶带,则被输送物料的温度不得超过150C。而TH、Hl系列由于提升机的牵引机构是环形链条,因此允许输送温度较高的物料。
The bucket elevator(D,TD,HL,TH series) manufactured by our company is warmly welcomed by clients.Amonng these series,the TD seriies and the TH series are characterized by multi specification,large conveying volume,high lifting height,stable driving,easy operation and maintenance and long service life etc.Its main performance and the technical parameter conform to the J8/T3926-99(《verticalbucket elevator》).This equivalence of standards refered to the international standard and foreign advanced standard.The round link chain of the HL and TH series conform to the MT36-80(《high strength mining round link chain》
The D type bucket elevator is suitable for upward conveying powdery,granular and small massive as wellas non-abrasive or semi-abrasive bulk materials,such as coal,coke braise,cement,broken ore and so on.The conveyed materials' temprature of the D,TH series elevator is not above 60 centigrade.IF using the anti-heat rubber belt ,the temprature shoud not exceed 150 centigrade While the TH and HL series allow conveying higher temprature material as the tractor of the elevator is an annular chain
斗式提升机的技术参数:the main technical parameter of bucket elevator
型号 | D型 | PL型 | HL型 | ||||||||
D100 | D250 | D350 | D450 | PL250 | PL350 | PL450 | HL300 | HL400 | |||
牵引 | 名称 | 橡胶运输带 | 板 链 plate link chain | 锻造环形链 | |||||||
B=200 | B=300 | B=400 | B=500 | 单链 | 双链 | 双链 | 双链 | 双链 | |||
料 斗 | 分深圆底形、 浅圆底形两种料斗,料斗固定于橡胶 带上 | 角形料斗链条固定于背面 | 大容量料斗链条固定于料斗两侧 | 分深圆底形、浅圆底形两种料斗,链条固定于料斗背面 | |||||||
卸载特征 | 间断布置料斗、快速离心卸料 | 连续布置料斗、慢速重力卸料 | 间断布置料斗,利用“离心投料法”进行卸料 | ||||||||
输送物料 | 粉状、粒状、小块状的无磨琢性或半磨琢性的散状物料,如煤砂、焦末、水泥碎矿石等。 | 块状,比重较大、磨琢性的物料如煤,碎石、矿石、卵石。另适宜输送易碎物料:如焦碳、木炭等 | 粉状、粒状及小块状的无磨琢性及磨琢性的物料如煤、水泥、石块、砂、粘土、尾石等。 | ||||||||
工作温度 | 被输送物料温度不得超过60℃如采用耐热橡胶带允许150℃ | 被输送物料的温度在250℃以下 | 允许输送温度较高的物料 | ||||||||
提升高度 | 约在4—30m范围内 | 约在5—30m范围内 | 约在4.5—30m范围内 | ||||||||
输送量 | 3.1—65m3/h | 22~100m3/h | 16~47.2m3/h | ||||||||
规格 | 提升机 | 型号 | HL300 |
输送量 | 42(m3/n) | 提升量 | 31.5(m) |
种类 | 垂直提升机 | 类型 | 板链式 |
品牌 | 郑州新光 |